DS SELECTOR (DRIVE SELECT)
Using the DS selector it is possible to select one of the following working programs:
A. Transfer: movement of the machine without working.
B. Scrubbing only : using only the brushes in the brush head.
C. Drying: using the squeegee only.
D. Scrubbing with Drying: using both the brushes and the squeegee.
Pressing one of the symbols in the selector will shift from the working screen (
Fig.1
) to the “DRIVE SELECT” screen (
Fig.2
). On this screen it is
possible to:
1.
Confirm the selected program.
N.B.:
to confirm the program press the icon just selected once again.
N.B.:
once the selection is confirmed you return to the working screen (
Fig.1
).
2. Cancel the selection and return to the working screen
N.B.:
to cancel the selection press the “back” button (1) (
Fig.2
) and you return to the working screen without changing the program being
used.
N.B.:
to cancel the selection wait 5 seconds without selecting anything and you will return to the working screen without changing the
program being used.
3. Select a mode other than the one highlighted.
ATTENTION: if you want to pass from a work program with the washing mode (only washing or washing
with drying) to the transfer program always remember to select the vacuum program for the time needed to
collect the detergent solution on the ground.
DRIVE
0000.00
100%
Back
0000.00
100%
A
B
D
C
1
1
2
TRANSFER
By selecting the "TRANSFER” program, the command display screen
will appear as in the adjacent figure.
N.B.:
with this working program both the brush head and the
squeegee support are put in the rest position (raised off the floor)
and the motors switch off with the respective switching off delays
(even if the drive pedal is not pressed). When the drive pedal is
pressed only the traction motor is powered.
N.B.:
In the DS selector, the transport program symbol (A) is
green (read the paragraph “
”).
N.B.:
the grey symbols show working programs that are not active. the
green symbols show working programs that are active.
The icons that may be visible on the control panel display are:
1. FFM symbol, if visible it shows that the system is operating.
2. FSS symbol, if visible it shows that the system is operating.
3. Working lights symbol, if visible it shows that the working lights are on.
4. General alarm symbol.
ATTENTION:
if this is visible, stop the machine; to continue working, see “
”.
DRIVE
0000.00
100%
6
9
5
7
8
1
4
2
3
23
