TYPE OF MAINTENANCE
AT THE END OF THE WORK
DAIL
Y
WEEKL
Y
BEFORE A
LONG
PERIOD OF NON-
USE
TRANSPORT
DRAINING THE RECOVERY TANK
X
X
X
CLEANING THE SQUEEGEE BODY
X
X
X
CLEANING BRUSH HEAD BRUSHES (SCRUBBING)
X
X
CLEANING THE RECOVERY TANK FILTERS
X
X
CLEANING THE RECOVERY TANK
X
X
EMPTYING THE SOLUTION TANK
X
X
X
CLEANING THE WATER SYSTEM FILTER
X
X
CLEANING THE VACUUM TUBE
X
X
7. Once the routine maintenance operations have been completed, take the machine to the area designated for storage.
ATTENTION:
Park the machine in an enclosed place, on a flat surface, and at a safe distance from any objects that could either damage
it or be damaged due to contact with the machine itself.
8. Secure the machine, see the section titled “
DRAINING THE RECOVERY TANK
Proceed as follows to empty the recovery tank:
1. Remove the drainage hose of the recovery tank from the clamps; it is located at the rear of the machine (Fig.1).
2. Bend the end of the drainage tube in order to create a choke and prevent the content from coming out (Fig.2), then
position the tube on the discharge surface, unscrew the cap, and gradually release the tube.
N.B.: The place given over to this operation must comply with current environmental protection regulations.
3. Repeat the operations in reverse order to reassemble all the parts.
2
1
ROUTINE MAINTENANCE
Before carrying out any routine maintenance operations, proceed as follows:
1. Take the machine to the maintenance area.
N.B.:
the place given over to this operation must comply with current environmental protection regulations.
2. Make sure the machine is in a safe condition (see chapter “
CAUTION:
it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
CLEANING THE SQUEEGEE BODY
The careful cleaning of the whole vacuum unit ensures better drying and cleaning of the floor as well as a longer suction motor life. To carry out
the cleaning of the squeegee body, proceed as follows:
1. Extract the vacuum hose (1) from the vacuum nozzle on the squeegee body (
Fig.1
).
2. Completely unscrew the knobs (2) in the squeegee body's pre-assembly (
Fig.2
).
3. Remove the squeegee body from the slits in the squeegee connector (
Fig.3
).
4. Thoroughly clean the squeegee body vacuum chamber (4) with a jet of water, and then with a damp cloth (
Fig.4
).
5. Thoroughly clean the squeegee body's rear rubber blade (5) with a jet of water, and then with a damp cloth (
Fig.5
).
38
