Fimap BMg 50 Orbital, Руководство по эксплуатации и обслуживанию

Страница: 14 / 52

PREPARATION OF MACHINE
MACHINE SAFETY
To ensure that work is carried out in the best safety conditions, proceed as follows:
1. Make sure the solution tank is empty. If this is not the case, empty it (read " EMPTYING THE SOLUTION TANK ").
2. Make sure the recovery tank is empty. If this is not the case, empty it (read " EMPTYING THE RECOVERY TANK ").
3. Lift the brush head body, and for PRO versions, press the “BRUSH HEAD CONTROL” button (1) on the control panel ( Fig.1 ). For PLUS
versions, using the DS selector on the control display ( Fig.2 ), select the “transfer ” program (3) (see “ DS (DRIVE SELECT) SELECTOR ”).
N.B.: as soon as the button (1) on the control panel is pressed, the green LED (2) (“BRUSH HEAD BODY WORK POSITION”) will switch
off ( Fig.1 ).
4. For PRO versions, lift the squeegee body and press the “SQUEEGEE CONTROL” button (4) on the control panel ( Fig.1 ).
N.B.: as soon as the button (4) on the control panel is pressed, the green LED (5) (“SQUEEGEE BODY WORK POSITION”) will switch off
( Fig.1 ).
5. Bring the main switch to position "0" by turning the key (6) a quarter turn anti-clockwise ( Fig.3 ). Remove the key from the instrument panel.
6. Get off the machine.
7. Press the recovery tank release lever (7) and turn the recovery tank into the maintenance position ( Fig. 4 ).
8. Disconnect the battery connector from the machine's main system connector ( Fig.5 ).
9. Rotate the recovery tank into the work position. Make sure that the recovery tank retainer system is correctly engaged.
Back
0000.00 100%
2
3
1
5
2
4
1
5 4 3
6 7
N.B.:
the ramp gradient must not be such as to cause damage to the machine as it goes up.
8. Once the machine is on the means of transport, set the main switch to “0” by turning the key (1) to the left ( Fig. 5 ). Remove the key from the
instrument panel.
9. Get off the machine.
10. Press the recovery tank release lever (8) and turn the recovery tank into the maintenance position ( Fig. 6 ).
CAUTION: the following operations must be carried out by qualified personnel. An incorrect connection of the connector may cause
problems with machine functioning.
11. Disconnect the electrical connector from the machine's general system.
12. Rotate the recovery tank into the work position. Make sure that the recovery tank retainer system is correctly engaged.
WARNING: secure the device according to the directives in force in the country of use, so that it cannot slide or tip over.
6
4 5 1
1 1
8
7
Back
0000.00 100%
2 3
6
4
5
2
3
14