9.9
SPECIFIC PROCEDURES
www.maxcessintl.com
DSE-45
MI 2-315 1 A
Assigning names for "Selected Applications" filtering
If desired, names for the devices and/or drives can be assigned.
Configuration
1.a.7
or
Names
1.a.7.1
or
Usage
1.a.7.1.2
or
To edit name
or
To move cursor position
1.a.7.1.2.1
1.
After filtering is properly setup and enabled, the items in the list of
devices are formatted as follows: Application ID, Sub Function,
Application Name, Drive Function (D1, D2, Gateway, etc).
For example: 5.3: Chill.PT1
"5" is the Application ID
"3" is the Sub Function
"Chill" is the Application Name
"PT1" is the Drive Function.
In the case of the Device with the Sub Function set to 0 (zero), the
Sub Function is blank, and the Drive Function is blank.
2.
Change the Usage name of the primary device (the device with its
Sub Function set to 0) to the desired name for the application. This
changes the Application Name for all devices with the same
Application ID. (This can be seen in the list of devices on the "All
Devices" screen, when filtering is enabled).
See
Names
in the Configuration menu structure on
page 8.8.
3.
Change the Usage name of the other devices in that application to
something that describes their function in the application.
Note: Sub Function 0 must be assigned to the primary device of
each application for the Application Name to show up in the list of
filtered devices. If the Sub Function number of the primary device is
not 0, "???" will be displayed for the Application Name in the list of
Fnamedevices.
