6. Commissioning
© Festo Didactic GmbH & Co. KG • 544305
89
LED colour
State
Red
power on
Yellow
charging
Green
charging completed
In order to replace the batteries, the command bridge must first be removed from
the chassis. Proceed as follows:
Required tool: 4 mm hex key
•
Undo all of the plug connections on the command bridge.
•
Remove the two hexagon socket head screws from the front, as well as the two
hexagon socket head screws from the centring plates underneath the command
bridge in order to dismantle it from the chassis.
•
Pull the command bridge up and out, and set it carefully aside.
•
Disconnect the cable lugs from the negative and positive battery terminals.
•
Open the battery holder.
Press down both ends of the clasp (1) on the top of the battery holder to this end,
and bend out the two retaining brackets (2). Set the clasp aside.
•
Remove the battery (3). Tip the battery towards the outside to this end, and lift it
out.
1
2
3
Clasp (1)
Retaining brackets (2)
Battery (3)
6.11
Replacing the batteries
