Battery Installation:
1.
To open, when looking at the back, press the two tabs along edge of battery cover to release. Gently lift the cover about 1 inch, and slide tabs out to
release and remove.
2.
Insert 6 AA batteries (follow the illustration inside the battery compartment). Ensure the batteries are inserted so that the flat ends are making contact
with the springs.
3.
To close, replace the cover by sliding the two tabs into the open side slits, and gently close the other side until the tabs snap into place securing
the cover.
Mounting Installation:
Mounting with magnets to metal tabs with 3M adhesive
Determine mounting location (Caution – adhesive tape may remove paint or damage the surface when removed.)
1.
On the metal tabs, peel and remove the tape backer to expose adhesive. Place bare metal sides against the
two magnets onthe back of the light bar.
Make sure the area where you want to attach the light is clean and clear of debris and dust.
Place the light bar in the desired mounting location. Firmly press the adhesive tape against your surface to mount the light.
Adjustable White Motion Puck and Light Bar Owner’s Manual
BL-PMTN-W Adjustable White Motion Puck Light | BL-BMTN-W Adjustable White Motion Light Bar
Puck Light
Battery Installation:
1.
To open, when looking at the back, twist back cover counter-clockwise and remove.
2.
Insert 3 AA batteries (follow the illustration inside the battery compartment). Ensure the batteries are
inserted so that the flat ends are making contact with the springs.
3.
To close, replace the cover and turn clockwise.
Mounting Installation:
Mounting with magnets to metal tabs with 3M adhesive
Determine mounting location (Caution – adhesive tape may remove paint or damage the surface when removed.)
1.
On the metal tab, peel and remove the tape backer to expose adhesive. Place bare metal side against the magnet on the back of the puck light.
2.
Make sure the area where you want to attach the light is clean and clear of debris and dust.
3.
Place the puck light in the desired mounting location. Firmly press the adhesive tape against your surface to mount the light.
Light Bar
