Manual Light Operation:
Determine if you want the light to operate on motion in any light condition, or only in the dark. Inside the battery compartment is a button
to change operation of light sensing on or off. The light will flash once to confirm the “light sensing on” setting, and flash twice to confirm
the “light sensing off” setting.
1.
Tap the lens to power on the light. The light will return to its last-used brightness and white color setting.
2.
If the last used setting was not 3000K (warm white) and 100% brightness, then tapping the lens again will return the light to 3000K at full brightness.
Repeated taps will cycle through white color temperatures: 4000K > 5000K > 3000K.
3.
To Dim – tap and hold the lens, the light will smoothly dim from 100% to 10% or until you release the lens at your desired light level. Release and re-press
the lens to restart the dimming cycle in the opposite direction. When holding the lens to dim, the light will stop at its lowest and highest dim levels.
4.
Once you have the white light color temperature chosen and the brightness, the light will turn off after 30 seconds of no motion and operate at the last
setting each time it sees motion.
5.
Light bar has a swiveling motion eye that allows you to focus the sensor to be more or less sensitive.
Warning
To reduce the risk of electrical shock, do not put the unit in water or other liquid. To clean, use a soft dry cloth. Do not place or store light where it can fall or be
pulled into a tub or sink.
Battery Precautions
1.
Use only the size and type of batteries specified.
2.
Always purchase the correct size and grade of battery most suitable for the intended use.
3.
Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
4.
Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel Cadmium) batteries.
5.
Replace all batteries of a set at the same time. Do not mix old and new batteries.
6.
Clean the battery contacts and also those of the device prior to battery installation.
7.
Do not dispose of batteries in fire.
8.
Remove batteries if consumed or if product is to be left unused for an extended period of time.
9.
Follow instructions for recycling for the batteries you use. (Lithium-ion batteries must be disposed of at a household hazardous
waste collection point (check with your local landfill) or battery recycling drop off location, NOT placed in the trash.)
Limited Warranty
Under normal use and conditions, AmerTac provides to the original purchaser of this product a one year express warranty that is
set forth in the Limited Warranty stated in full at www.amertac.com/warranties.
©2021 AmerTac™
250 Boulder Dr.
Breinigsville, PA 18031
610-336-1330
www.amertac.com
Made in China
BO_TL_052_0521
Page 2
