Federal Signal Corporation CAMLCD-AHD-70, Инструкция по установке и эксплуатации

Страница: 52 / 68

48
Operating the Mobile Camera System
Priority for the camera triggers is, from highest to lowest: Camera 1 >
Camera 2 > Camera 3 > Camera 4. In other words, the Camera 1 trig-
ger has the highest priority and overrides other triggers.
Menu options
Press the MENU button for these options:
•
COLOR
: Adjusts the amount of color information in the image on the
monitor on a scale of 0 to 24.
•
BRIGHTNESS
: Adjusts the degree of brightness in the image on the
monitor on a scale of 0 to 24.
•
CONTRAST
: Adjusts the amount of contrast in the image on the
monitor on a scale of 0 to 24.
•
VOLUME
: Adjusts the volume of the sound from the selected
camera microphone on a scale of 0 to 24, as applicable.
After you press
MENU
, select one of the options by moving up and
down the menu with the – (down) and + (up) buttons and pressing the
MENU
button. The selected menu item is red; all other options are
yellow. Then adjust the scale that appears with the – (decrease) and
+ (increase) buttons. The scale disappears after approximately eight
seconds of inactivity.
The
MIR/NOR
button on the monitor enables you to temporarily
switch the displayed image of the camera to either a mirror image or
a normal image. This setting is set in memory so that even when the
system is turned off, the preferred setting is recalled when you turn on
the system. However, in a system using the CAMLCD-70, it is recom-
mended that the mirror/normal configuration is set with the switches
on the back of the CAMBOX-4NTSC/CAMBOX-4PAL for each of
the up to four cameras connected to the system. These switches pro-
vide a mirror/normal setting that is preserved regardless of different
split-screen views on the monitor.
Option 3: System Configured with a CAMLCD-INT-70-B
monitor (as in CAMSET70-NTSC4B/CAMSET70-PAL4B)
When you turn on the camera system by turning the vehicle ignition key to
either the “Accessory” or “On” position, the monitor operates in one of two
ways, depending on the
POWER BUTTON
setting in the monitor menu.