Federal Signal Corporation CAMLCD-AHD-70, Инструкция по установке и эксплуатации

Страница: 51 / 68

47
Operating the Mobile Camera System
CA1 CA2 CA3 CA4
POWER QUAD
290A6054B
GREEN LEDS INDICATE
WHICH CAMERA
IS SELECTED
RED LED
INDICATES
POWER
GREEN LED INDICATES
THAT QUAD VIEW IS
SELECTED
Figure 10. Camera system keyboard
To manually turn the system off, press the
POWER
button on the key-
board. The red standby LED on the
POWER
button will light. To manually
turn the system on, press the
POWER
button on the keyboard briefly. The
split-screen image of all connected cameras, or the last screen configura -
tion selected (if power has not been removed), will appear on the monitor.
The red LED on the monitor turns off when the system is powered on and
an image is displayed. Please note that pressing the
/CAM SEL
button
on the monitor can also turn the monitor on and off in this system, but using
the keypad is recommended.
Automatic camera triggering
Automatic triggering of connected cameras is supported as follows:
• To automatically turn on Camera 1, apply 12V–24V to the green
wire. This can both power the monitor from standby and select
Camera 1.
• To automatically turn on Camera 2, apply 12V–24V to the white
wire. This can both power the monitor from standby and select
Camera 2.
• To automatically turn on Camera 3, apply 12V–24V to the yel-
low wire. This can both power the monitor from standby and
select Camera 3.
• To automatically turn on Camera 4, apply 12V–24V to the blue
wire. This can both power the monitor from standby and select
Camera 4.