Federal Signal Corporation CAMLCD-AHD-70, Инструкция по установке и эксплуатации

Страница: 14 / 68

10
Installing the Mobile Camera System
Marking and Drilling the Mounting Holes for
the
Rear-View Camera
AIRBAG DEPLOYMENT
Do not install equipment or route wiring in the deployment path
of an airbag.
Failure to observe this warning will reduce the effectiveness of
the airbag or potentially dislodge the equipment, causing serious
injury.
SEAT REMOVAL PRECAUTION
If a vehicle seat is temporarily removed, verify with the vehicle
manufacturer if the seat needs to be recalibrated for proper airbag
deployment.
Failure to heed this warning could result in death or serious injury.
LOCATING OPERATORS CONTROLS
Locate the camera(s), monitor, keyboard, control box, and digital
video recorder (as applicable) so the VEHICLE and SYSTEM can
be operated safely under all driving conditions.
Failure to heed this caution could result in driver distraction or
driver error while operating the vehicle.
DRILLING PRECAUTIONS
When drilling holes, check the area into which you are drilling to
be sure you do not damage vehicle components while drilling. All
drilled holes should be deburred and all sharp edges should be
smoothed. All wire routings going through drilled holes should be
protected by a grommet or convolute/split loom tubing.
1. Use the camera mounting bracket as a guide to mark the loca-
tions of two to four mounting holes to be drilled into the vehicle
(Figure 1 on page 9). These locations should lie in the two chan-
nels on either side of the circular hole in the center of the bracket.