Federal Signal Corporation CAMLCD-AHD-70, Инструкция по установке и эксплуатации

Страница: 21 / 68

17
Installing the Mobile Camera System
3. Connect the camera extension cable (one CAMCABLE-
SHORT/-5/-10/-15/-20/-40 or two connected in series with CAM-
CABLE-EXT) or special DVR cable (as applicable) to the camera.
4. Wrap the cable connection in the supplied black waterproofing
tape.
Installing the Flush-Mount Camera
(CAMCCD-FLSHNTSC/CAMCCD-FLSHPAL)
Before the installation, find an appropriate location for the flush-mount
camera with these considerations in mind:
• Although the camera is waterproof, repeatedly exposing it to direct,
high-pressure streams of water (as from a pressure washer) is not
recommended.
• Decide whether you will be mounting the camera to the vehicle with
the included bracket or flush to a vehicle surface.
• The material properties and thickness of vehicle bodies vary widely.
The included hardware can accommodate many different vehicle
installations. However, it is recommended that you exercise judgment
when drilling holes into vehicle surfaces.
• When drilling into a vehicle structure, be sure that both sides of the
surface are clear of anything that could be damaged. Remove all burrs
from drilled holes. To prevent electrical shorts, grommet all drilled
holes through which wiring passes (all Federal Signal cameras include
grommets). Also, ensure that the mounting screws do not cause
electrical or mechanical damage to the vehicle.
• This camera is recommended for flush-mount installation on a vehicle.
As an alternative, a mounting bracket is included for mounting above
the surface of the vehicle.
• The camera should be positioned so that the driver can obtain a wide,
unobstructed field of vision.