Fayat DYNAPAC CC1400C, Инструкция по эксплуатации, Страница: 88 / 239

Operation
4812164601_C.pdf 2023-01-05
Operator position
1
2
3
Fig. Operator's station
1. Seat belt
2. Safety railing
3. Rubber element
If a ROPS (Roll Over Protective Structure) is fitted to
the roller, always wear the seat belt (1) and wear a
protective helmet.
Always replace the seat belt (1) if it shows signs of
wear or has been subjected to excessive strain. Always replace the seat belt (1) if it shows signs of
wear or has been subjected to excessive strain.
Check that the platform's rubber elements (3) are
in good condition. If the elements are worn this
will have a negative effect on comfort. Check that the platform's rubber elements (3) are
in good condition. If the elements are worn this
will have a negative effect on comfort.
Ensure that the platform floor is clean to avoid the
risk of slipping. Ensure that the platform floor is clean to avoid the
risk of slipping.
1
2
Fig. Articulated joint
1. Nut
2. Washer
3. Articulated joint holder
3
Adjusting the Off-set
Lift up the front drum just above ground level.
Place a jack on the rear frame,
to support the articulated joint, and loosen the nuts
on the articulated joint (1).
Position yourself on the right or left-hand side of the
articulated joint.
Use the requisite tools (for example, a rubber covered
steel bar) and hit the articulated joint holder (3). The
articulated joint holder now moves sideways.
When the adjustment is made, make sure
to tighten the nuts on the articulated joint (1)
to the right torque again.
(See the table for tightening torque in the
“Technical data” chapter)
72