- 45
Instructions to Update Firmware after Revision V119K:
Necessary tools and components: Micro SD Card - 4GB or smaller.
1. Open the Evolution machine door. The power should remain on during this
entire process.
2. Open the inner door located to the left of the window opening on the inside of
the door.
3. The VMC Board is located at the top of the opening and the Digital Display
Board is located directly below the VMC. Unlatch the right side of the Display
Board and flip it around so that the display may be viewed from the back of the
door.
4. The Microprocessor (daughter) Board is located on the upper right corner of
the VMC Board. Remove the Micro SD card from its SD adapter and carefully
insert it into the metallic slot located on the upper right corner of the daughter
board.
Notes -
•
The Micro SD card should be inserted straight down into the slot.
•
The contacts on the Micro SD card should face away from you.
•
The lettering on the card will be facing you.
•
There should be an audible “click” when the card is seated.
•
If the card does not drop smoothly into the slot, remove and retry.
***DO NOT FORCE THE MICRO SD CARD INTO THE SLOT**
SAVE BIN CONFIGURATION AND DEX FILES: (Firmware after Revision
V119K)
5. The Display will scroll between the options on the Micro SD Card menu:
1- Load Config.
2- Save Config.
3- Load Firmware
4- Save DEX Sales
Enter “2” to save your current bin configuration. Name your bin configuration
appropriately using the naming convention described in the previous section (see
Fig. 12). . Press “#” to save your bin configuration to your Micro SD card. Push
down slightly on your Micro SD card and then let it go. It will pop up slightly in
the socket.
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | + 561-391-7200
