- 17
General Maintenance and Cleaning
Lubrication
Do not use oil or any other lubricants on moving parts. Lubricants may damage
the mechanical and electronic components.
General Cleaning Considerations
It is important to maintain the machine in accordance with this manual. The
cabinet, freezer, door and delivery bin should be periodically wiped down with a
non-abrasive damp cloth and vacuumed as necessary.
To allow for proper air flow, the fan located in the lower rear corner of the cabinet
should be cleaned using a cloth at regularly scheduled intervals. Those intervals
will be dictated by the cleanliness of the location. All machines should be
cleaned at least once a month.
Disconnect power prior to servicing any electrical or moving components
including the fan. Do not pull on wires that supply power to any components.
Failure to comply may result in damage to the vendor and increased risk of
electric shock.
To avoid the possibility of a fire hazard and to decrease the possibility of
restricted airflow into the vendor, do not store anything or allow debris to
accumulate on the bottom of the door, inside or behind the cabinet, near the fan
or in the general area of the vendor.
Do not use water, soap or any other liquid to clean the inside of the vendor. The
outside of the cabinet and glass can be cleaned using a soft cloth and a mild
detergent. Never use flammable materials to clean any part of the vendor.
Setup instructions
Currency Systems
•
The Evolution Vendor supports
only
24 - 34 volt Multi-Drop Bus (MDB)
Money Systems
•
The Evolution Vendor is compatible with any MDB compliant, level 2 or
higher coin mechanism or bill validator as well as most card readers and
telemetry systems.
The Evolution vendor leaves the factory pre-wired with a DEX port located inside
the door near the left side of the window frame. To collect sales data using the
DEX port, insert the plug from your DEX handheld into the port and pull out the
pin on the 3 position service/door/interlock switch. The door switch is located
below the threads of the T-Handle bolt on the back of the door. It is necessary
for the machine to have a unique identification number entered into the serial
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | + 561-391-7200
