- 43
11. Press the pound (#) key to enter the selection. The Display will read,
“Programming”. An LED status light on the right side of the VMC Board will start
flashing rapidly. When the process is complete, the display will read, “UPDATE
SUCCESS. Remove card…”
12. To remove the Micro SD card, press down gently on the top. It should slide
up slightly allowing you to grasp it between your fingers. Lift the SD card straight
up and out.
Notes -
•
Power does NOT have to be turned “OFF” to remove the SD card.
•
The vacuum may produce a clicking sound during this procedure.
This is normal and is not a concern.
•
A major firmware upgrade may require the Robot Arm to be re-
calibrated. Please refer to the section, “Calibrating the Robot Arm”
in your manual. Scroll to Service Menu Option “4) Create
Selection”, Press “#” and follow the prompts to calibrate the Robot
Arm.
•
Your programming data will need to be re-entered after this
upgrade. Go to Service Menu Option 4) Create Selection, Press
“#” and follow the prompts to program your machine. Going
forward, the data will be saved and automatically re-installed as
part of the upgrade process.
13. If you have multiple machines with the same bin configuration, insert your
Micro SD card into the Daughter Board Slot after programming your first
machine. The power should remain on during this entire process.
•
Use the “*” key to scroll to menu option “2 - Save Config”. Enter “2” to
save the new configuration onto your Micro SD card.
•
Choose a name for your bin configuration and save the file onto your
Micro SD card (see Fig. 12 in the next section). Carefully, remove the
card from the daughter board.
•
After installing the Boot Loader and Program Upgrades onto your
machines, install the Micro SD card to load your bin configuration onto
your remaining machines. Enter “1”, “1 - Load Config”, and then choose
the name that you used to save your bin configuration.
•
Follow the steps to load the bin config onto the remaining machines.
•
Test-vend selections to confirm accuracy. Go to Service Menu 3) Edit
Selection to make adjustments if necessary.
Please contact Tech Support at 888-441-3278 if you have any questions.
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | + 561-391-7200
