Fast 8300, Руководство по эксплуатации

Страница: 35 / 42

8300 Liquid Fertilizer Applicator 34 FAST AG Solutions
4.2 Maintenance
4.2.1 Adjust Gauge Wheel Height
1. Loosen U-bolts (A).
2. Remove pin (B) and adjust gauge wheel height as
desired.
3. Install pin, lock pin and tighten U-bolts (A).
4.2.2 Nozzles
1. Clear area of bystanders.
2. Extend wings and raise tool bar to its fully up posi-
tion.
3. Place safety stands under center tool bar or install
transport lock spacers over lift cylinder rams.
4. Nozzle Angle:
•The best results are obtained when nozzle directs
liquid approximately 1 inch (25 mm) behind
coulter.
•Loosen setscrew (A) to set nozzle at required
angle and centered behind coulter.
5. Nozzle Spray Pattern
•Sight along nozzle and coulter. Nozzle should
direct liquid directly behind coulter.
•Loosen setscrew (B) to adjust nozzle spray paral-
lel with furrow.
4.2.3 Filter
1. Clean the filter at the start of each day when tank
is empty or dirt is detected in system.
2. Clear area of bystanders.
WARNING
Prevent serious injury or death.
Check chemical or fertilizer MSDS for
proper handling instructions.
Toxic chemicals can enter the body by
breathing, spray or contact with bare skin.
Do not take a chance with your health and
safety.
3. Close sump valve (A) if there is liquid in tank.
4. Relieve pressure in liquid circuit.
5. Remove cap (B) to access screen.
6. Use clear water to clean screen.
7. Install screen in canister and tighten by hand. Do
not over tighten canister and crack head.
8. Open sump valve (A) if there is liquid in tank.