Fast 8300, Руководство по эксплуатации

Страница: 28 / 42

8300 Liquid Fertilizer Applicator 27 FAST AG Solutions
16. Coulters:
Coulters are used to cut crop residue on surface,
penetrate ground and part the soil to accept liquid
from nozzle. Coulter depth is controlled by
spacers on lift cylinder ram and gauge wheel
position.
Inspect coulters frequently if operating in rocky
conditions. Bent, chipped or broken coulters will
not penetrate soil properly. Always remove
entangled material from any component.
Coulter With Injector Nozzle
Coulter With Knife
17. Gauge Wheels:
Each inner wing and flip wing is equipped with a
gauge wheel that helps to maintain application
depth. Lower gauge wheels if soil conditions are
soft and raise if hard to obtain the same
application depth.
18. Depth Control:
Install spacers on tool bar lift cylinder ram to give
required machine depth. Tool bar can then be fully
lowered and always return to same depth.
19. Nozzles / Knives:
Refer to TeeJet’s nozzle/orifice application rate
table to determine correct of tip or orifice.
As a general guideline, tip of nozzle should be
slightly above ground as unit moves over the field.
This will insure that liquid enters soil via furrow
and is retained in soil as the furrow closes.