Fast 8300, Руководство по эксплуатации

Страница: 27 / 42

8300 Liquid Fertilizer Applicator 26 FAST AG Solutions
•Toolbar is now in position to begin field applica-
tion.
•Check amount of down pressure applied to
main wings by engaging remote #2 continuously
and lowering coulters into the ground while
remaining stationary with unit. Hydraulic down
pressure gauge should read between 700 and
1500 psi. Down pressure may be adjusted by
turning socket head screw on down pressure
valve located on toolbar near wing fold manifold.
•Use only as much down pressure as needed to
get coulters to proper depth. Excess pressure
could cause damage to toolbar. Turn socket
head screw clockwise to increase pressure and
turn counter clockwise to decrease down pres-
sure. To change pressure, loosen jam nut, turn
adjustment stem a 1/4 turn at a time. Do not
exceed 1500 PSI.
•Reverse the tractor remote #1 to fully raise tool-
bar and kick wings up. Toolbar is now ready for
field application.
14. Outer Wing Valve - 40 Ft Machines:
Chemical lines to outer wings have a valve to shut
off flow to nozzles on flip wing. Turn valves (E) off
to get a 30 ft. application width. Open valves when
30 ft. requirements are finished. Right wing valve
illustrated.
15. Application Depth:
•Depth of material placement can vary depending
on type of application. Check with fertilizer or
chemical manufacturer for information regarding
application depth. Set tool bar, coulter or nozzle to
required depth.
•Once desired field location of application is
reached, center section and main wing kick may
be lowered by engaging the tractor remote #1.
Even after coulters are in ground, tractor remote
#1 must be constantly engaged providing oil sup-
ply to and from down pressure circuit.
•Failure to keep tractor remote #1 engaged and
supply a constant oil flow to down pressure sys-
tem will result in coulter riding out of the ground,
and could result in structural failure of the toolbar
and/or hydraulic cylinder components.