Fast 8300, Руководство по эксплуатации

Страница: 26 / 42

8300 Liquid Fertilizer Applicator 25 FAST AG Solutions
11. Fresh Water Rinse Tank:
•Each machine is equipped with a fresh water
rinse tank (B) on rear frame.
•Fill rinse tank with clean fresh water whenever
rinse water has been used. Do not allow tank to
run low on fresh water.
•Use water from rinse tank to clean, rinse or wash
anything that has become contaminated.
12. Ground speed:
•It will be necessary to establish travel speed and
then set flow to give desired application rate.
•Always run at established travel speed.
•Best results are obtained when ground speed is 5
- 8 mph.
•Ground speed variations in the field will automati-
cally be compensated.
•Always operate at a comfortable speeds.
•Do not operate so fast that tool bar or tank
bounce while going through the field. Effective
results require that liquid be applied at a consis-
tent depth in a consistent manner. Machine
bouncing will prevent this required consistency.
13. Unfolding/Extending Tool Bar:
•Verify tool bar is fully raised.
WARNING
Prevent serious injury or death.
Machine coming near or contacting power
lines can cause electrocution.
Electrocution can occur without contact.
Fully lower wings before moving or
transporting.
NOTICE
Prevent wing rest damage.
Never engage tractor remote lever to
lower center section (orange labeled hose)
while main wings are in transport position.
•Engage tractor remote #1 to raise main lift and
main wing kick cylinders to the fully raised posi-
tion.
•Remove transport brace (C) from main lift cylin-
ders.
•Remove safety pin from main wing hinge on both
sides.
•Engage tractor remote #2 to unfold main wings
from the saddled transport position. When main
wings are fully unfolded, they will remain “kicked”
up until center section is lowered during field oper-
ation.
•Engage tractor remote #3 to unfold outer flip
wings to the field position.
•Insert flip wing lock pin (D) into holes to lock flip
wing in field position.