FaderMate Master Control Unit, Руководство по фитингам

Страница: 30 / 36

Figure 4.7.2 - Typical Fader Audio Connections
To remove an existing fader in order to replace it with a moving fader, either de-solder or
cut each of the 3 wires. If you choose to cut the wires, it is important to leave as much
‘slack’ as possible (i.e. to cut the wire very close to the soldered terminal on the fader)
otherwise the wire may not reach the motorised fader.
It is important to remember which of the 3 wires is ‘top’, ‘wiper’ and ‘ground’ for every audio
fader which is to be replaced.
TIP: It is a good idea to label the wires as they are disconnected from the original
faders.
30