FaderMate Master Control Unit, Руководство по фитингам

Страница: 27 / 36

4.6 System Connectivity Test
At this stage it should be possible to test that the FaderMate system is connected together
correctly.
WARNING: Please do not power the system up before performing all of the steps
described so far in this section in order.
It is also necessary to double-check all of the power connectors to ensure that the
polarity has not been reversed. Powering the system up with the power supply
wires connected incorrectly may cause serious damage.
Connect the MCU to the mains using the supplied IEC cable. Turn the MCU power on
using the front panel rocker switch.
You should observe the following:

The MCU front panel indicator LEDs labelled +12V , +5V and CPU (Figure 4.5.1, red
box) should all light immediately

The MCU front panel indicator LED for each connected FCU (Figure 4.6.1, yellow
box) should light solid green
Figure 4.6.1 - MCU Front Panel Indicator LEDs

The LEDs labelled +3V3 , +5V and +12V (locations shown in Figure 4.6.2) on each
FCU circuit board should all light immediately
27