EZ EZ-220, Руководство по оборудованию

Страница: 76 / 150

72
EZ-TEXT-M-E
Text Panel Hardware Manual
value with the panel ARROW Keys (READ/WRITE)?
h.
If you select READ/WRITE Access, you can enter a Minimum and
Maximum Range that the operator can write to the PLC.
i. You will notice that Password Protection is not available for the
EZSeries Set Point Display Text Panel models covered by this
manual. Password Protection is only available in the EZ-220P
model, that offers a keypad for numerical data entry.
j. You may confi gure DATA 1 to display a decimal point that is
controlled by the PLC. The location of the decimal point must
be confi gured in your PLC ladder logic program. Place a check
mark in the box next to PLC Controlled Decimal Point and then
enter the PLC Address where the control resides. (This is DATA
1 only — you cannot confi gure PLC Control for a DATA 2 or DATA
3 embedded value.)
If PLC control for the decimal point is enabled, the program will
place a decimal point at the end of the characters representing the
data value in the Message Text fi eld — 1111. in the fi gure above.
Then placing a value of 1–4 (BCD) or 1–5 (Decimal) in the PLC
Click on this button
to add a folder
Click on this button
to add a message
1 Enter text here 2 Click here to accept text
3 Confi gured Message will appear here Total characters in
current message is
shown here
NOTE: Folders can
have up to 19
characters maximum.