Page | 61
20.3.
BATTERY INSTALLATION
20.3.1.
Set replacement batteries in same orientation as the batteries previously removed.
Field-replaced batteries do not use double-back foam tape or hook and loop fastener.
20.3.2.
Insert bolt (removed earlier) through battery hold down, between batteries, and through
power head mounting plate (FIG. 20.1).
20.3.3.
Put washer and locknut on bolt and tighten nut until washer makes contact with the bottom of
the power head mounting plate, then turn another quarter turn.
20.3.4.
Do not overtighten! A properly tightened battery hold down will allow slight twisting
movement with fingers (FIG. 20.2).
Battery hold down will keep batteries in place with bolt & nut only lightly tightened.
Battery hold down cannot be easily twisted with fingers when over-tightened.
When over-tightened, battery cases will be visibly distorted in the areas where the
battery hold down is in contact with the battery casing (FIG. 20.2).
An over-tightened nut will cause stress on battery cases that could result in cracks and
leaking of battery acid (FIG. 20.2).
FIG. 20.1
FIG. 20.2
Содержание Passport PL44SP3651
Страница 27: ...Page 27 FIG 9 1 FIG 9 2 ...
Страница 65: ...Page 65 23 ELECTRICAL DRAWING ...
Страница 66: ...Page 66 WIRING DIAGRAM 44 52 72 120 144 AND 168 PASSPORT LIFT ...
