Page | 40
10.3.9.
Tap a
5/16”
-18 threaded round tube insert into the end of the 1-
1/2” diameter tube,
opposite the end you installed the connector plate on (FIG. 10.5).
10.3.10.
Orient the connector plate as shown (FIG. 10.5) with the clamp plate below the handrail
tube and toward the platform side of the gate post.
10.3.11.
Slide the assembly into the back channel in the gate post closest to the platform post
where it will connect with the clamp plate inside the channel and the connector plate on
the outside of the post. Slide down until the
5/15”
-18 threaded hole of the round tube
insert aligns with the hole in the platform r
ail post (FIG. 10.5) and insert a 5/16”
-18 hex
head bolt thorough the platform angle post and threading it into the threaded hole of
the round tube insert.
10.3.11.1.
Do not tighten fully at this time.
10.3.12.
Repeat the procedure for the remaining handrail tubes.
10.3.13.
Tighten all hardware.
10.3.14.
Reinstall the post cap and insert the 3/8” push in plugs
(if equipped) in the open holes
between the hex washer head screws in the platform post (FIG. 10.5).
FIG. 10.5
Содержание Passport PL44SP3651
Страница 27: ...Page 27 FIG 9 1 FIG 9 2 ...
Страница 65: ...Page 65 23 ELECTRICAL DRAWING ...
Страница 66: ...Page 66 WIRING DIAGRAM 44 52 72 120 144 AND 168 PASSPORT LIFT ...
