EZ-ACCESS Passport PL44SP3651, Руководство по установке

Страница: 55 / 68

Page | 55
16.2.2. Assemble the two mounting bars to the call/send control using four #10- 24 x 3/4” long
button head socket cap screws and nylon locking nuts (FIG. 16.2). Assemble the bars in such a
manner that the larger hole is on the gate side when mounted to the same post which
contains the latching mechanism.
16.2.3. Install two 5/16” - 18 x 3/4” long button head socket clamp screws through the larger holes in
the mounting bars and into the tapped holes in the attachment bar. Do not tighten fully at
this time.
16.2.4. Remove the post cap.
16.2.5. Attach the call/send control and mounting assembly by sliding the attachment bar into the
channel at the back of the latch mounting post while the mounting bars remain on the
outside the post.
16.2.6. Slide the assembly below the latch bar and tighten the clamp screws securely. This should
clamp the post wall between the attachment bar and the mounting bars, holding the
call/send control in place.
16.2.7. Reinstall the post cap.
16.2.8. If not done so previously, bring the 3-pin connector out of the VPL tower in the same manner
described in SECTION 15 and connect it to the cord in the VPL tower.
16.2.9. Secure the call/send control cord to the porch or deck in such a manner that it will not
interfere with the VPL or gate operation or pose a tripping hazard.
FIG. 16.2