Mounting
This section describes how to mount the TLP 350CV Cable Cubby enclosure. The TLE 350 is
installed in exactly the same way. The section covers covers:
•
•
Tools Required for Installation
•
•
Ensure Adequate Under-table Clearance for Retractors
•
•
•
Installing Cable Retractors (Optional)
•
Installing Power Modules (Optional)
•
Preparing and Installing the AAP Assemblies
•
•
Bottom Panel Features (TLP 350CV only)
Planning
1.
Before making any cuts, select the best location for the enclosure.
Ensure that the edge that opens on the lid is oriented correctly.
Ensure there is enough space for all the system cables and components, above and
below the table. Take account of:
•
Clearances for under-table cabling, especially if the cable has a large bend radius.
•
Ensure Adequate Under-table Clearance for Retractors
if they are to be
installed (see page 8).
•
The number and type of AAPs required for the installation.
•
The location of devices that connect to the AAPs either above or below the table.
2.
Verify that you have the correct template or
3.
Decide on the method for cutting a hole in the table (see
There are three methods available:
•
— requires a router template, which must be
purchased separately.
•
— must be programmed with the correct dimensions.
•
— requires a paper template (available at
).
The hand router used with the routing template or the CNC wood router are the most
accurate methods for cutting the hole. Either one of these methods is recommended by
Extron. The jigsaw is less accurate, but is also acceptable.
4.
Check all relevant regulations.
Ensure that the installation complies with local, state, and national building and electrical
codes.
Ensure that the installation complies with the Americans with Disabilities Act or other
accessibility requirements.
TLP 350CV and TLE 350 • Mounting
6
Содержание TouchLink TLP 350CV
Страница 6: ......
Страница 8: ...TLP 350CV and TLE 350 Contents viii ...