Extron electronics TouchLink TLP 350CV, Руководство пользователя

Страница: 16 / 54

Ensure Adequate Under-table Clearance for Retractors
Retractors are optional accessories for handling cables with the TLP 350CV. If you are using
retractors, ensure that there is sufficient room beneath the table to accommodate them.
Horizontal mounting provides maximum legroom and protects the retractors from accidental
damage. Vertical mounting is used if space or access makes horizontal mounting difficult. To
satisfy ADA compliance requirements, there is also an option to mount the retractors at a 30°
angle (see the
Retractors User Guide , which is available at
www.extron.com
).
Horizontal Mounting Clearance
XL Models
Vertical Mounting Clearance
XL Models
3.0"
(7.6 cm)
2.7" (6.9 cm)
17.0"
(43.3 cm)
23.0" (58.5 cm)
24.1"
(61.2 cm)
30.1"
(76.5 cm)
2.7" (6.9 cm)
9.8"
(24.9 cm)
3.0"
(7.6 cm)
9.8"
(24.9 cm)
Figure 4. Under-table Clearance Requirements for Retractors
Cutting the Table
Cut-out Dimensions
There are three alternative methods of making the hole for the TLP 350CV (see Cutting the
Surface below):
•
If using a Router with routing template , you should purchase the TLP 350CV routing
template.
•
If using a CNC router , use the exact cut-out dimensions.
•
If using a Reciprocating saw or jigsaw use the paper cut-out template.
Cutting the Surface
WARNING:
Wear safety glasses when operating power equipment. Failure to comply can
result in eye injury.
AVERTISSEMENT : Portez des lunettes de sécurité lorsque vous utilisez l’équipement
électrique. Ne pas respecter cela peut conduire à une blessure à l’oeil.
TLP 350CV and TLE 350 • Mounting 8