EWIKON L2X, Руководство по эксплуатации

Страница: 45 / 88

45 HPS-III-Heißkanalsystem_Elektro-System_BA_V-2-0_EN
General information for wiring of standard hot runner systems
Position of nozzles in the mould
Most EWIKON hot runner systems are delivered as complete hot halves. As far as there is no differing specification from
the customer side, the position of the nozzles is defined as following: When viewing from the parting line in direction of the
nozzle tips, the nozzles are numbered line-by-line from top left to bottom right according to the scheme shown below. If the
manifold has multiple heaters, the same numbering scheme is applied. The power and thermo collective plugs are numbered
consecutively:
(230 V: X-1.1, X-2.1, X-3.1... / Thermo: X-1.2, X-2.2, X-3.2....).
EWIKON recommends to apply this numbering scheme also when purchasing components instead of hot halves.
Picture 32: General information for wiring of standard hot runner systems
z218-08
230 V Thermo
X-1.1
X-1.2
X-2.1 X-2.2
Wiring box with power and
thermo collective plugs
Stationary mould half Moving mould half
A - A
view on tips
Electrical connection of hot runner systems