Evoqua WALLACE & TIERNAN SFC, Оригинальное руководство пользователя

Страница: 160 / 288

160
WT.050.590.000.DE.IM.0719
Operation
SFC
6.
100% If the display blinks, the positioner is in manual mode and cannot
be activated.
28.4°C Sample water temperature
mA? 1/5 Error indication active (display bottom right)
The system has detected an error. The error can be identified
using the table in chapter 6.5 “Errors and remedies”. The number
combination states the series number of the error message and
the total number of error messages (in this example: 1. first error
of a total of five).
PI 85 s YPI stop time display. The time it takes after a spike in the flow rate
for the single feedback closed loop control in the compound loop
to reactivate.
Scroll bar
This is used to indicate the actual menu position of the menu
arrow. If the selection mark is at the top, the menu arrow is on
parameter 1 (see example). A maximum of eight parameters per
display is possible.
The SFC provides the option to assign a customer-specific name
or designation to each measurement. In the menu „System -
Module designation“, a text of up to six characters can be defined,
e.g. „Inlet“, „Main“, „Tank“ etc. This name is displayed in the main
display under the associated measurement. If blanks (default
setting) are entered as a module name, it is deactivated and does
not appear in the main displays.
General messages
Adaption is currently running!
This message appears if an attempt is made during adaption to
automatically calibrate the positioner.
This function is possible in the MANUAL mode only!
This message appears, for example, if an attempt is made to
calibrate the positioner during automatic operation. Acknowledge
by pressing ENTER or the ESC key.
A module has been removed!
Do you wish to adopt the new configuration?
This message appears when the unit is switched on, after a
module has been removed. Confirm with the yes/no key.
New hardware component found!
This message appears when the device is switched on after
addition of a module.
No data available!
This message appears when there is no configuration saved on
the SD memory card and an attempt is made to load a
configuration from the SD memory card.
1
TANK