U2829 Series Operation Manual Chapter 2 Introduction
5
8)
[TRIG]
When the trigger mode is set to MAN mode, press this key to trigger the
instrument.
9)
[RESET]
Press this key, when transformer auto scanning is cancelled, other operation
cannot be executed on other pages.
10)
PASS indicator and FAIL indicator
LED indicator shows the test result has passed or failed.
11)
Numerical keys
These keys are used to input data to the instrument. The key consists of
numerical keys [0] to [9], decimal point [.], [+/-],[ESC],[
←
] and [ENTER]
key.
12)
[MEAS]
Press this key to enter into the display page of transformer scanning test.
[SETUP]
Press this key to enter into the setup page of transformer scanning test.
[SYSTEM] Press this key to enter into the system setup page.
[FILE] Press this key to enter into the file list page.
13)
CURSOR
This key is used to move the cursor on the LCD displayed page. When the
cursor moves to a zone, the corresponding zone will be lightened.
14)
Knob for menu selection and numeric input
This knob is used to move the cursor, select and set parameters.
15)
[SAVE]
Copy the currently displayed page to USB memory.
16)
Brand and model
Brand and model
17)
USB HOST interface
Connect U flash disk so as to save or use a specified file.
18)
[KEYLOCK]
Press [KEYLOCK], it will be lighted, which means the function of current panel
is locked. Press it again, it will be off, which means discharging the lock status.
If the password function is ON, it means correct password is necessary when
discharging the key-lock, or the key cannot be unlocked.
19)
[DC SOURCE]
This key is used to permit or forbid the output of a 10V individual voltage
source.
20)
[DC BIAS]
[DC BIAS] is used to permit or forbid the output of 0-100mA/10V DC bias
source. Press this key, it will be lighted which means DC bias output is
permitted. Press this key once more, it will be off which means DC bias output
is prohibited. The key is useless in some pages where the DC BIAS cannot be
added.
