ESPEC BTL-433, Инструкция по эксплуатации

Страница: 24 / 60

Criterion Series Benchtop User’s Manual
21
4. Installation
This chapter explains how to install the chamber and prepare for tests. Be sure to read the parts on
installation even if having the chamber installed by the place of purchase or ESPEC. Also, refer to this
chapter whenever relocating the chamber.
4.1. Installation
4.1.1. Installation Site Check
This section describes installation site and space requirements.
Installation Site
Install the chamber in a place which satisfies the following conditions.
•
On a flat, level bench which is strong enough to bear the weight of the equipment.
•
Where subject to only minimal mechanical vibrations.
•
Where not exposed to direct sunlight but which is well-ventilated.
•
Where ambient temperature is +5 ~ +35°C and free of sharp temperature fluctuations.
(0.1°C/min. or 3°C/30 mins.). Performance specifications are only guaranteed within a
temperature range of 18 – 27 °C
•
In a dust-free room.
•
Which is not exceptionally wet or humid.
•
Away from flammables and explosives.
•
Where not exposed to combustible or corrosive gases.
•
Near to power, water and drainage utilities.
•
Not directly underneath or near to fire alarms.
Note
Chamber working temperature range is 15 ~ 35°C. Using the chamber outside of this range will
lead to equipment problems.
Installation Space
The chamber requires operational and maintenance space on the left and right sides. It must
also be a safe distance from objects on the front side so that the door can be opened.
*This dimension is the operating space required.
Maintenance space required is 24” (61.2cm),
however the chamber can be easily moved for
maintenance.
Fig. 4.1. Installation Space
A
A
B
C
D
A : Min. 4” (10 cm)*
B : Min. 24” (61 cm)
C : Min. 36” (91.8 cm)
D : Min. 0” (0 cm)*