Esko Kongsberg XP, Руководство пользователя

Страница: 151 / 218

12
Kongsberg XP
The Knife Pressure is modified if Speed Dependent Tool Pressure is specified, see below.
During the tool down movement, the knife moves down until the material surface is detected and the
proper Knife Pressure is achieved.
The Knife Pressure needed will vary depending upon the material.
For a typical Vinyl Cutting Job , a recommended start parameter is Knife Pressure = 65-70 gram and
Speed Dependent Tool Pressure = 50%.
Note:
For the
PressCut to work properly, a sharp Knife Blade is critical.
Pay special attention to the tip of the Knife Blade , as it is easy to break.
Speed Dependent Tool Pressure
In the dialog, specify Ramp and a Ramp Value .
The Ramp Value is entered as a % - value.
The upper curve illustrates the speed of the
machine when executing a line.
Curve A illustrates the
Knife Pressure if the Speed
Dependent Pressure is set to 0; the pressure is
constant from start to stop.
The
Knife Pressure level is as specified by the
Knife Pressure parameter, see previous chapter.
Curve B illustrates the
Speed Dependent Tool
Pressure .
Ramp Value is set to 100.
When running at full speed, the pressure is the
double of the Knife Pressure A.
This function is useful as it allows a lower pressure
in both ends of a line where the speed is low at
the same time as you get a higher pressure when
running at full speed.
Note: The maximum
Ramp Value is 200%.
151