Esko Kongsberg XP, Руководство пользователя, Страница: 98 / 218

12
Kongsberg XP
*) Tip : When adjusting Tool Height for perforation or Crease wheels , move the tool outside the material
surface. Set the height so that the tool tip touches the table top surface before manually jogging the
tool through the material. Complete wizard and inspect
Crease /perforation result (should yield a good
quality Crease or perforate all the way through material).
For more information about how to run the Adjustments Wizards, see Tool Configuration and
Adjustment on page 64.
Note :
• For the Dual HDU , remember to always complete Tool Adjustments for the P1.1 position first.
• The HD Perf position is adjusted as a separate tool, despite being connected to the main Dual HDU
structure.
• The HD Perf position is not compatible with V-Notch Knife Tool or HD30 knife. The HD Perf position
will automatically be disabled from SW if one of these tools are identified in tooling position P1.1
• The tool mounted in the HD Perf position must be removed before inserting a V-Notch Knife Tool in
position P1.1 (will not fit if not).
12.8.2. New mounting procedure for HD insert tools
Inserting the tools into the Tool holder fork follows the same procedure as described in the separate
tool insert sections. The procedure for fixing them in place is however different for the Dual HDU :
Insert the Locking Pin from one side until it snaps in place. No Cotter pin is needed from the other
side.
For HD inserts other than HD Crease , remember to use both pins.
Note : Check that the pin is inserted all the way in.
98