Esko Kongsberg XP, Руководство пользователя

Страница: 107 / 218

12
Kongsberg XP
For a 90 degrees folding angle, the nominal recommendation is to decrease the width of the cut by
twice the bottom liner thickness. The
Width offset function can be used to adjust the width between
-50 to 10 mm / -1.97 to 0.39 in. Example: If your liner is 1 mm / 0.04 in. thick, the Width offset should
nominally be -2 mm / -0.08 for a 90 degrees fold. This will depend on the material and potential flute
direction. The nominal
Width offset values for other angles are added to the VariAngle tooling presets .
They can also be calculated by using the following formula:
• Width offset = (-2) x Liner thickness x Tan( notch angle )
To remove the waste of a V-notch Crease that is still connected to the board, the Waste Cut function
can be enables. This function adds a third cut to the line at specified distance from the second cut.
12.9.7. Workflows, set-up and optimization
Please use references and links below for different resources:
• Workflow
• iPC manual, section Optimal Production Workflow .
• Get the best out of iPC, manual (English): Various sections, see Contents.
• eLearning (English):
https://learning.esko.com/course/view.php?id=23#section-1 .
• Mapping presets
• iPC manual, section Before we start # Mapping Presets
• Get the best out of iPC, manual (English): Appendix 1 - iPC Resources # Setting up Mapping
presets .
• eLearning (English): https://learning.esko.com/course/view.php?id=23#section-1 .
• Tooling presets
• iPC manual, section Before we start # Tooling Presets
107