ES&S DS850, Руководство оператора

Страница: 163 / 199

Chapter 10: System Messages 157
EVS5200_DOC_SOP_DS850
Software Version 2.10
Published: February 26, 2014
1009539 - Camera
Interface - Virtex FPGA
generated empty
interrupt X X This message appears if the Virtex
FPGA (field-programmable gate array)
device's communication with the BAPis
Image Processor Board generated an
unexpected, empty interrupt. Write down the error message and notify an
appropriate election official. If possible,
shutdown and then turn off the Scanner. Wait 30
seconds and then turn the Scanner back on. If
the problem persists, the Virtex FPGA may need
to be replaced. Contact an ES&S Service
Technician. Since the BAPis Board is a “COTS”
(Commercial Off The Shelf) product, the ES&S
Technician may have to contact a BAP Technician
to fix the problem.
1009540 - Camera
Interface - Error in
image processor FLASH
memory X X This message appears if an error occurs
within the FLASH Memory of the BAPis
Image Processor Board. Write down the error message and notify an
appropriate election official. If possible,
shutdown and then turn off the Scanner. Wait 30
seconds and then turn the Scanner back on. If
the problem persists, contact an ES&S Service
Technician. Since the BAPis Board is a “COTS”
(Commercial Off The Shelf) product, the ES&S
Technician may have to contact a BAP Technician
to diagnose the problem.
1009541 - Camera
Interface - Unsupported
camera command
protocol X X This message appears if the BAPis
Image Processor Board receives an
unexpected command (out of the
established sequence of camera
commands) to issue to the camera(s). Write down the error message and notify an
appropriate election official. If possible,
shutdown and then turn off the Scanner. Wait 30
seconds and then turn the Scanner back on. If
the problem persists, contact an ES&S Service
Technician. Since the BAPis Board is a “COTS”
(Commercial Off The Shelf) product, the ES&S
Technician may have to contact a BAP Technician
to diagnose the problem.
System Messages
NOTE: A System Halt is a condition which requires the DS850 to be shutdown. It is not a condition which prevents the scanning of ballots.
Message Text
Message
Displayed
Message
Printed
Message
Logged
Results in a
System Halt
Cause Resolution