Epson Stylus Color 800, Руководство по обслуживанию

Страница: 138 / 187

EPSON Stylus
&RORU
800
Rev. A
4-18
4.2.7 Head GAP Timing Adjustment
Head GAP Timing Adjustment is required when the C202 MAIN board or the Printhead is replaced (or
disassembling and assembling the CR unit) to correct the vertical misalignment caused by different print
timings between black and color inks. This adjustment, same as for the Bi-d adjustment, is performed by
entering the adjusting value. Therefore the adjusting values are stored in the EEPROM on the C202 MAIN
board. The adjusting procedure is described below.
1. Set this program to FFD on your PC and turn the PC on.
2. The program automatically sets up and the following menu appears on the screen.
3. Enter “1” for “Select menu : ?” to select “Input of Customer data” in the menu.
4. Press “ENTER” key, and the menu below appears.
5. Enter the 4-column code which corresponds to the destination for “Memory-SW data (4 col data)”
and press “ENTER” key. (See the code list in Page 4-6.)
6. Enter “2” for “Select menu : ?” to select “Adjustment/Print inspection” in the menu.
Input Customer data
Adjustment/Print inspection
Changing of center value
Input of comment
Change of date
Change of time
END
Select Menu ?_
.....................
..............
................
........................
..........................
..........................
1
2
3
4
5
6
9
Stylus COLOR 800 J70C00E
Customer : Standard Customer DATA <**** > 12-03-1996
Figure 4-24. Main Menu
Input Customer data
Adjustment/Print inspection
Changing of center value
Input of comment
Change of date
Change of time
END
Select Menu : 1
Input the customer data
Memory-SW data (4col data) : ?
.....................
..............
................
........................
..........................
..........................
1
2
3
4
5
6
9
Stylus COLOR 800 J70C00E
Customer : Standard Customer DATA < **** > 12-03-1996
Figure 4-25. Input of Customer Data