Epson RS Series, Руководство по обслуживанию

Страница: 89 / 122

RS3 RS4 Maintenance 9. Bellows
RS series Maintenance Rev.3 79
Bellows
Installation (1) To attach the bellows, move the shaft to its upper limit.
To move the shaft up/down, press and hold the brake release switch.
Be sure to keep enough space and prevent the end effector hitting any peripheral
equipment.
Be careful of the shaft falling while the brake release switch is being pressed because
the shaft may be lowered by the weight of an end effector.
(2) Pass the shaft through the bellows from the larger joint.
(3) Secure the cover side of the bellows.
The bellows has two joints:
The larger joint must be attached to the cover side.
The smaller joint must be attached to the end face
side of the shaft.
Be careful not to misplace the clamp bands. The
clamp band has two sizes; small and large.
Attach the mounting part of the bellows until the
end touches the cylindrical part of the cover.
Bellows
(cover side)
Attach the rubber sheet. Be sure to attach the
rubber sheet so that no space is made between the
bias cut.
Bias cut
Then, secure them with clamp bands.
Bellows
Rubber sheet
Clamp band
(4) Apply the liquid gasket uniformly.
- Mating point of the bearing inner race
- Inside of the bearing base
Bearing
case
Mechanical
stop
Apply the
liquid gasket
here
(5) Mount the bearing and the bearing case.
(6) Mount the mechanical stop.