Epson EMP-7300, Руководство по обслуживанию

Страница: 5 / 110

(2) LIMITATION OF PARTS
* Use only authorized or supplied parts from EPSON for the replacement of
mechanical parts including the lamp inner housing, fuse, air filter and so on.
* Use only the power cable and the interface cables attached with the product.
(3) Others
* Visually checks the distortion or dirt at the connectors of the power cable. If dirty,
clean off, and if distorted, replace the cable in order to avoid firing by the flush over
phenomenon.
* When plug the internal connector cables or the interface cables, be sure to fully plug
into the connectors until it stack to the connector edge.
* When remove the FPC cable of the light valve are sure to remove the connector lock
in advance. The connector lock should be unlocked by pulling up the both end of
connector lock simultaneously with tweezers.
* Whenever doing removal of parts or repair work on the product, make sure that the
work is done in a clean room, free of dust and dirt in order to keep the optical
element away from dirt.
3. REQUIREMENT FOR THE MAINTENANCE PERSON
Authorized person should have the following knowledge and skill for the maintenance
of EMP-7300.
* Need to be trained by EPSON authorized maintenance training program and to be
authorized as a service engineer.
* Need to sufficiently understand the operation and the descriptions of this service
manual.
* Need to have the basic knowledge of electricity (safety operation, circuit diagram,
electrostatic, and else...)
4. OTHERS
* Any questions on the RS-361/RS-376 maintenance including supply of the service
parts or contents of the document would like to be contacted to the below address.
Any technical information about amendments is occasionally available as the service
bulletin.
SEIKO EPSON CORPORATION
4897 OH-AZA SHIMAUCHI,
MATSUMOTO-SHI, NAGANO-KEN 390 JAPAN
TEL: 81-263-47-5603
FAX: 81-263-48-5680
ATTN: Visual Device Customer Support Group