94
Operating Instructions - EmoTouch 3
Service settings
EN
6.1.11 Post-heating temperature
This setting is available only in humidity mode. It is used to set the temper-
ature for the post-heating time.
See also
6.1.8 Fan post-cycle period,
90 and 6.1.10 Post-heating time,
Setting the post-heating temperature
1
Open the service settings.
See 6.1.1 Opening service settings,
2
Tap
and confirm the selection.
3
Set the value with
and
, and then confirm by pressing
.
The value can be set to any number between 30°C and 115°C. The
interval is set to 30 minutes by the factory.
6.1.12 HOT function
This setting is available only in Finnish mode. It allows you to define the
time and temperature for operation at high temperatures in order to heat
up the sauna stones to a maximum temperature before and/or during an
infusion phase and keep them hot.
You can define a time period for the HOT function. During this period, the
sauna heater heats at full power without interruption and independent of
the control hysteresis and the actual air temperature. The heating process
is interrupted for safety reasons once the air temperature reaches 115°C.
°C
Setting
01. June 2019
After-heating temp.
85
09:16:42
Example
: HOT time period
Start time = 10:00
End time = 21:00
