24
Operating Instructions - EmoTouch 3
Commissioning
EN
Setting the load for lighting to resistive load
1
WARNING! Ensure that the relay box is disconnected from the power
supply.
Open the relay box's housing.
Refer to the installation instructions.
2
Disconnect the light source from the relay box.
3
Reconnect the power supply and switch on the relay box and control
panel.
4
Press and hold
for 3 seconds.
5
Enter the code and confirm.
Code
8001
: Inductive load/resistive load, e.g. if light bulbs are used.
Code
8002
: Capacitive load.
6
Disconnect the relay box from the mains supply and reconnect the light
source.
7
Close the housing again.
8
Reconnect the relay box to the power supply and switch it on.
0
1 2 3
4 5 6
7 8 9
C
Setting
code
01. June 2019
08:44:40
