84
Operating Instructions - EmoTouch 3
Service settings
EN
6.1.3 Switching hysteresis
You can set the switching hysteresis for a range of 1K to 10K. This allows
you to change the upper and lower temperature limit, which determines
when the control unit switches the sauna heater on and off. It allows you to
adjust the temperature control to accommodate the size of the cabin with
greater accuracy and optimize heat production.
Example — 90°C target temperature and hysteresis 5K: The sauna heater is
switched on at 85°C and switched off at 95°C.
The interval is set to 5K by the factory.
Note that decreasing the value results in much more relay switching and
therefore shortens the service life of the control unit.
Setting the switching hysteresis for the sauna heater
1
Open the service settings.
See 6.1.1 Opening service settings,
2
Tap
and confirm the selection.
3
Set the value with
and
, and then confirm by pressing
.
The value can be set to any number between 1 and 10.
Enable
ONE
NONE
1200
19200
Enable
30
Disable
TWO
ODD
2400
38400
Disable
EVEN
4800
57400
9600
115200
Stop bits
Parity
Baud Rate
Address
KNX
Modbus
Settings
01. June 2019
09:16:42
