15
EN
How to remove the display panel
In order to remove the display panel, use the included removal tool or a
similar suitable tool like a flat headed screwdriver.
Insert the two tools into the grooves on the side edge of the control pan-
el (between control panel and wall housing) and lever the control panel
from the wall surface, then pull it out of the wall housing. Make sure that
the connection cable can also be removed from the wall housing.
Remove the connection cable from the RJ-plug on the control panel. For
this purpose, carefully press on the small securing tab of the plug and pull it out of the connector.
Important note:
For the removal, use the tools exclusively for the provided grooves in the control panel.
Under no circumstances may the tools be used elsewhere! This can damage the glass of the
control panel. In this case, the warranty is void!
ca. 3 m
ca. 3 m
Bauteil
Fig. 10
Installation of the housing upper part (control panel with display)
Place the control panel directly in front of the housing base and pay attention to the correct orien-
tation. Plug in the connection cable with the RJ10 plug to the control panel. Now press the control
panel carefully into the housing base until the fastening tabs lock securely. Make sure the control
panel sits reliably in the base part.
Notice: When you lay the connection cable do not pull it too tight, allow some extra length around
the base, so that later you can easily take the control panel out of the base while still having it
connected.
Fig. 11
use tool
here
The voltage regula-
tor must be mounted
within a radius of ap-
prox. 3 m (cable length)
away from the control
panel.
Voltage regulator
