Integrated Synchronous Servo Drives
HBI 22xx / HBI 26xx / HBI 32xx / HBI 37xx
Operating Manual Rev. 1.6
www.engelantriebe.de
page 45
Program start
Before starting the program, the HBI drive must be supplied with operating voltage and the connection to the PC / laptop
must be established with a serial connection cable (see chapter 6.2
).
The DSerV service software is started through execution of the file DSerV.exe from the working directory on the hard
disk. (Comment: The program start from a removable data carrier is not possible.)
After the start-up of the service software the DSerV program window (see below) appears and the communication to the
connected device is automatically established.
Note
:
If no communication to the drive is established after the program start, check the following:
Is the correct interface port selected on the PC / laptop?
(
Options
/
Com-Port
)
Is the drive switched on?
Is the serial cable plugged in at the PC / laptop and the drive?
(If necessary, only plug in the serial cable after the drive has been supplied with operating
voltage.)
Does the *.dav file in the working directory correspond to the type of drive and the
firmware used?