PC830 Firmware Upgrade Instructions
Before you begin
Remove AC power from the drive and
wait 5 minutes
until the bus discharges.
Warning
High voltages are present on the PC830 connections. Follow the instructions
outlined below to avoid an electrical shock.
Tools required
·
Small flat head screw driver
·
Medium phillips screwdriver
·
Chip extraction tool (supplied in upgrade kit)
Procedure
There are static sensitive devices inside the drive. Perform installation in static
free environment.
1. Unconfigure drive to clear non-volatile (NV) memory.
2. Remove all external connections from the drive.
3. Remove the screw that attaches the plastic cover to the aluminum heatsink.
Make sure the drive has been powered down for at least 5 minutes.
4. Use a small flat head screwdriver to gently lift the two plastic tabs that hold
the cover in place. Once both plastic tabs are free from the aluminum tabs
the cover should slide freely.
903-083002-01
PC830 Firmware Upgrade Installation
1
