Endress+Hauser Silometer FMC 672 Z, Инструкция по установке и эксплуатации

Страница: 7 / 64

1 Introduction
Quick Operating Guides The front cover contains short instructions for the standard set-up, continuous level
measurement with capacitance probes, which is used in 80% of applications.
For Users familiar with the operating matrix of Hauser Commutec transmitters
in general and the Silometer FMC 672 Z/677 Z in particular, a Quick Operating Guide for
the most important operating modes is to be found in Chapter 10.
In this manual Users unfamiliar with the Silometer FMC 672 Z/677 Z must read the operating
instructions. Since it is not possible to describe all applications in detail, the standard
application used in 80% of all applications, continuous level measurement, has been
used as the basis for the functional description. Other applications as listed in Section 1.1
are described in Chapter 8. The instructions are structured as follows:
•
Chapter 1: Introduction;
contains general information including application, measurement
principle and functional description.
•
Chapter 2: Installation;
contains hardware configuration, installation instructions.
connection diagrams and technical data for the plug-in card.
•
Chapter 3: Controls;
describes operation with the front panel keys, Commulog VU 260 Z
and ZA 672.
•
Chapter 4: Calibration and Operation;
tells you how to commission the Silometer for the standard
application of continuous level measurement.
•
Chapter 5: Linearization
tells you how to calibrate the Silometer to measure volume in a
horizontal cylindrical tank or a tank with a conical outlet.
•
Chapter 6: Analogue Outputs;
describes in detail the setting of the 0/4
…
20 mA signal line.
•
Chapter 7: Limit Switches;
describes in detail the setting of the relays.
•
Chapter 8: Other Applications;
describes the configuration of the Silometer for further applications not
covered in Chapter 4.
•
Chapter 9: Trouble-Shooting;
contains a description of the self-checking system with error
messages, the simulation feature as well as instructions for
configuration on replacement of the transmitter, probe or electronic
insert.
•
Chapter 10: Quick Programming Guide;
provides configuration flowcharts for the principle applications.
•
Chapter 11: Index;
lists key words to help you find information quickly.
Further documentation In addition to this manual, the following publications provide information on configuration
of the Silometer FMC 672 Z/677 Z.
•
BA 028 Commulog VU 260 Z handheld terminal
•
BA 054 ZA 672 Modbus Gateway
Installation of the probes, electronic inserts and accessories are described in the
documentation accompanying these articles - see text for references. When installing
probes in explosion hazardous areas the instructions included in the accompanying
probe certification must also be observed.
Silometer FMC 672 Z/677 Z Chapter 1: Introduction
5