3.5. Setting up the device
• The unit should be placed on a flat, level surface. Do not use the unit if it is at an angle.
• Only demineralized or distilled water should be used in the devices. The use of incorrectly specified
water (see "3.2. Supply water quality") reduces the sterilization efficiency and leads to loss of warranty
due to damage to the device.
• Leave a space of 5 cm at the rear of the appliance and at least 1 cm at the sides of the appliance from
walls or other elements for proper ventilation and fresh air access.
• The unit should be located to provide easy access to the main switch located on the rear panel of the
unit.
• Do not place the unit near a sink with water or other places where the unit could be flooded - danger
of short circuit.
• The device should be installed in a well-ventilated room, far from heat sources and rooms where
mixtures of gases or liquids or other dangerous factors may arise.
The following conditions must be ensured for safe and efficient operation of the device:
• ambient temperature from + 5 ° C to + 25 ° C,
• relative humidity from 0 to 90%,
• storage temperature from -20 ° C to + 60 ° C,
• 0 to 90% relative humidity.
3.6. Connecting the device to the power supply
Connect the appliance only to power sources that are grounded and equipped with residual current
protection, and that have the same voltage rating as the appliance (see "12. Technical Data").
It is unacceptable to use extension cords to connect the device to the power source.
Connecting the device to an incorrect power source may damage it and void the warranty.
1 cm
5 cm
18
19
