3.4. Connection with water recycling (Enbio Magic Filter)
Enbio Magic Filter is a filter for recycling water used in the sterilizer. The ion-exchange resin contained
in Enbio Magic Filter allows you to purify wastewater to the level of deionized water in accordance with
the requirements of EN 13060 - that is, water which is recommended and approved for use with Enbio
autoclaves. You only need 1 water tank to use Enbio autoclave with filter.
3.4.2 WATER OUT wastewater connection with Enbio Magic Filter
• Connect the red wastewater hose to the orange wastewater connector that is marked on the rear panel
of the WATER OUT device. The tubing should be inserted into the connector, to the depth of the black
line (placed on the tubing).
• Wastewater should be drained into a water tank. To secure and immobilize the water drain hose from
the unit, use the plug supplied with Enbio Magic Filter and insert the plug into the opening of the water
tank. The unsecured tubing may jump out of the tank and flood the room.
• Make sure that the red tube is never immersed in water, otherwise the water will not drain properly,
causing sterilization errors.
• The water tank must always be located below the unit.
3.4.1 Connection of feedwater WATER IN with Enbio Magic Filter
• Connect the shorter part of the blue Enbio Magic Filter connection hose to the blue water supply
connection, which is marked on the rear panel of the WATER IN device. The tubing should be inserted
into the connector, to the depth of the black line (placed on the tubing).
• Submerge the longer part of the blue Enbio Magic Filter hose into the feed water tank. The unit is
equipped with a water intake pump, so there is no need to place the water tank above or at the same
level as the unit
• To ensure proper operation, Enbio Magic Filter must always be placed in a vertical position
• To prevent the hose from coiling in the water tank, install the included weight with a rubber ring at 2
cm from the end of the hose (fig.)
• To secure and immobilize the water supply hose to the machine, use the plug supplied with the Enbio
Magic Filter and insert the plug into the opening of the water tank. An unsecured tubing may jump out
of the water and cause sterilization errors.
• The minimum water load in the tank is 300 ml.
• Remember and check that the blue tube is always immersed in the water.
• Check the water level in the tank on a regular basis, depending on the frequency of the processes
Correct connection of
the hoses to the feed and
wastewater connections
Correct installation of the
weight with the securing ring
Correct positioning of the
hoses in the water tank
16
17
