Emerson Rosemount 56, Инструкция по эксплуатации

Страница: 61 / 136

Instruction Manual Section 6: Programming Measurements
LIQ-MAN-56 April 2017
Programming Measurements 51
6.8 Ozone Measurement Programming
This section describes how to configure the 56 analyzer for ozone measurement using
amperometric ozone sensors. The following programming and configuration functions are
covered:
1. Units: ppm Select ppm, mg/L, ppb, µg/L
2. Resolution: 0.001 Select display resolution 0.01 or 0.001
3. Filter: 5sec Override the default input filter, enter 0-999 seconds
6.9 Oxygen Measurement Programming
1. To program measurement Units, Select ppm, mg/L, ppb, µg/L, % Sat, %O2-Gas, or ppm
Oxygen-Gas and press ENTER/MENU.
2. To program the Measurement Resolution: Select 0.01 or 0.001 and press ENTER/MENU.
3. To Override the default input
filter, enter 0-999 seconds and press ENTER/MENU.
6.10 Turbidity Measurement Programming
This section describes how to configure the 56 analyzer for Turbidity measurements. The
following programming and configuration functions are covered.
1. Measurement type: Turbidity Select
Turbidity or TSS calculation
(estimated TSS)
2. Sensor type: Select EPA or ISO
3. Measurement units: NTU, FTU, FNU
4. Filter: 20 sec Override the default
input filter, enter 0-999 seconds
5. Bubble Rejection: On Intelligent
software algorithm to eliminate
erroneous readings caused by bubble accumulation in the sample
1. To program the Measurement type,
Select Turbidity or TSS
calculation (estimated TSS)
and press ENTER/MENU.
2. To program the Sensor type:
Select EPA or ISO and press
ENTER/MENU.
3. To program Measurement units:
NTU, FTU, FNU and press
ENTER/MENU.
4. To Override the default input filter,
enter 0-999 seconds and press ENTER/MENU.
5. To program Bubble Rejection, select On or Off and press ENTER/MENU.