15
We offer appropriate power supply units for DC drive mechanisms. In case of need,
please indicate the type of motor, manufacturer and – if available – technical data.
Pass the cable for voltage supply and drive mechanism through the rubber sealing at
the bottom side of the weather station and connect voltage (L1/N/PE) and drive
mechanism (PE/N/up/down) to the provided clamps.
Note: The programme button for the wireless connection is on the weather station
board. To teach the wireless connection to the control unit, please see Chapter
"Commissioning" and "1st Wireless Connection to the Weather Station" in the basic
settings.
Close the housing by putting the cover over the bottom part. The cover must engage at
the right and at the left with a clearly noticeable “click”.
Check whether cover and bottom are correctly
engaged! The figure illustrates the closed
weather station from below.
Mounting of the weather station
Push the housing into the mounted holder from
above. The journals of the holder must engage
with the rails of the housing.
If you want to remove the weather station, you must pull it out of the holder in upwards
direction against the resistance of the engagement.
