9
Installation and Commissioning
DANGER!
Risk to life from live voltage (mains voltage)!
There are unprotected live components inside the device.
•
Inspect the device for damage before installation. Only put undamaged devices into
operation.
•
Comply with the locally applicable directives, regulations and provisions for
electrical installation.
•
Immediately take the device or system out of service and secure it against
unintentional switch-on if risk-free operation is no longer guaranteed.
Use the device exclusively for building automation and observe the operating
instructions. Improper use, modifications to the device or failure to observe the
operating instructions will invalidate any warranty or guarantee claims.
Operate the device only as a fixed-site installation, i.e. only in assembled condition and
after conclusion of all installation and operational start-up tasks, and only in the
surroundings designated for it.
Elsner Elektronik is not liable for any changes in norms and standards which may occur
after publication of these operating instructions.
Installation of weather station and
connection of drive mechanism
Position
Select an assembly site at the building where wind, rain and sun may be collected by
the sensors unobstructedly. Do not assemble any construction components above the
weather station from where water may drop on to the rain sensor after it has stopped
raining or snowing.
The weather station may not be shaded by the building or for example by trees. At least
60 cm of clearance must be left all round the weather station. This facilitates correct
wind speed measurement without eddies. The distance concurrently prevents spray
(raindrops hitting the device) or snow (snow penetration) from impairing the
measurement. It also does not allow birds to bite it. Please ensure that an extended
awning does not cast shade on the unit, and that this is not protected from the wind.
Temperature measurements can also be affected by external influences such as by
warming or cooling of the building structure on which the sensor is mounted, (sunlight,
heating or cold water pipes).
View of rear side for the weather station
All values are in mm, deviations due to technical reasons are possible.
